lots and lots of parts
This is basically every sensor for the motor plus tune up parts, gaskets, etc. It also includes a wideband O2 + controller!
This is Innovate Automotive's LC-2 wideband O2 controller. Fully tunable controller, but does not come with a gauge, which is fine since im getting one to match the other gauges i already have from NVU.
I mocked up the exhaust in the bronco, and found a good place to install a bung for the wideband sensor, just behind the stock sensor:
I removed my 2-gauge pod from my pillar, and am installing a 3-gauge pod from GlowShift. Its actually a pretty nice piece and fits very well.
This is the harness i built for the oil pressure & trans temp gauges; its built around a 6 pin connector, and i was only using 5. This works out super conveniently, because i only need to add 1 wire to this harness for the air-fuel ratio gauge- the signal wire from the wideband controller. The rest of the wires for the gauge are all already there. So wiring the gauge will be a pretty simple task.
Here's the new Bosch wideband O2 sensor:
Here's the wideband controller:
Just a couple wires to connect to make it work, plus the large plug goes to the O2 sensor, the other 2 plugs are optional. One of the small plugs is an input for connecting a laptop for tuning the controller, and the other one is an output if youre using other software/hardware from Innovate.
Here's the included harness that connects the sensor to the controller. its available in several lengths; i got the 8' one because i dont know how im going to route the wire yet.
And it also included this adapter harness for connecting a laptop for datalogging or tuning the controller:
Its unlikely ill need this, but it would be useful for those who like to do more specialized tuning for racing, or want to use the controller to emulate a narrowband sensor.
Ive already started wiring the controller up in the truck, but i havent routed the cable for the sensor yet. Its difficult to say exactly where i want it to go, w/o an engine or transmission in the truck to check for clearances. Hopefully the engine will come back soon, and i can get this thing back together and running!
I have a torque converter on order from Broader Performance, hopefully it comes soon.
I also decided its worth it to just order a tuner, so friday i ordered the PimpX ECU from Stinger Performance.
main site/photo gallery:
Sort by Topic