somebody had to do it. |
|
Gauging6/17/2017 So I figured since I have money & time invested in the engine & trans, I might as well get some gauges to monitor them. Enter a set of Autometer's GS gauges:  Trans temp probe in the usual location; the test port  Built a simple manifold to allow me to use both the stock pressure sender & the autometer oil pressure sender  Working on the wiring harness. Since the GS series are LED, I have a resistor in-line to dim them a bit, so they match the dash brightness  some wires poking out of the a-pillar...  ...and gauges done!  Looks like the motor is ~45 PSI cold, and never drops below 20 PSI even when hot @ idle. Haven't seen trans temps above 140º yet, altho I haven't driven it much since I finished em. Comments are closed.
|