The 315s are doing well, glad i bought em. Rides so much better than the beat 305s i had.
So, i was lost in the dark corners of the interwebs, and found these:

They are Switchback LEDs from Amazon
The turn signal is your typical amber:

But the parking circuit is white:

​Theyre pretty cool actually. The white parking light turns off when they blink orange, then turns back to white when you turn the blinker/hazards off. No wiring required, just plug em in. Theyre surprisingly bright, and the color matches my LED headlights well.

What is this, updates on two vehicles in the same month?!

​Finished the passenger side fender liner:

Closed off the hole for the body mount, and made a small panel to fit between fender & firewall to keep door hinges cleaner

Moved to the back, and cut some more sheet metal off the rear wheel well

Then painfully pushed the truck over a couple feet towards the center of the garage, and cut the rear left:

Both need some final feathering to clean up the endges, but thats the final shape. Obviously need to finish trimming the bottom corner, but im not going to do that until i get a new tailgate and see where i want to cut to.

Then moved to the front left, and started bending up more sheetmetal!

​Lots of room under the hood still:

small panel to close in the corner

And the finished liner:

This side definitely went a lot faster than the other did, now that i had a rough idea of what i wanted to do. For now im calling them done; i might go back way later and add pieces here or there, but i think this is gonna work pretty good. Hopefully next week i can rip it all back out, and begin priming & painting all the pieces. I also want to yank the front clip, so i can paint the inside of the fenders black, along with the section of firewall thats still white. Then i can put it all back together and move on to the floor pan!